Meguiar's M888 Beyond Ceramic Paint Coating - Professional Ceramic Paint Coating Installation Guide

This installation guide will help you get the most out of our Professional Beyond Ceramic Paint Coating M88800.
0:11 Wash - Wash the vehicle using a pH-balanced car wash and dry it.
0:24 Iron Decontamination - Spray an iron decontaminant and agitate with a wet wash mitt and rinse thoroughly.
0:40 Remove Bonded Contaminants - Use detailing clay and a spray detailer to remove bonded contaminants.
0:59 Paint Correction (Optional) - Use compound and polishes to remove paint defects.
1:42 Final Prep - Remove all oils from the paint using a surface prep product. Repeat the process and inspect the paint with a paint inspection light.
2:19 Application - Liberally apply the coating to the included microfiber applicator and place face down on the paint, pushing and twisting for 5 seconds to prime it. Apply in a small section using 50% overlapping strokes in a crosshatch pattern. Let dwell for 2-4 minutes. Add more coating to the applicator as needed or if the product becomes difficult to spread. If coverage is not even, try using slightly more pressure or try using slightly more product.
3:23 Wipe Off - After letting the product sit and dwell for 2-5 minutes, buff coating off with a clean microfiber until no visible product remains. Discard towels after use.
3:40 2nd Coat (Optional) - This coat is to ensure even coverage. You can immediately start the 2nd application, or wait up to, but no longer than, 2 hours.
3:52 Inspect - Inspect paint in good lighting to ensure the coating is leveled. If excess product exists, level with a clean microfiber. Keep vehicle dry for 24 hours, coating is fully cured after 7 days. Do not wash our use chemicals for at least a week.
4:32 Recommended Maintenance - Use a pH-balanced car wash frequently. Use a ceramic-based detailer or spray wax as often as desired to keep the coating looking and performing its best. Do not use clay, compound, polish, or waxes on the coating as these will remove or diminish the effect of the coating.
5:26 Results