Скачать или смотреть Arduino Tutorial - Servo Motor Control with Potentiometer

Control the position of a RC (hobby) servo motor with your Arduino and a potentiometer.

Hardware Required

Arduino or Genuino Board
Servo Motor
10k ohm potentiometer
hook-up wires
mini breadboard

Similar Videos -

Home Automation -    • How To Make Bluetooth Control Home Automation  

LCD Tutorial -    • Arduino Tutorial - LCD Display Control  

Stepper motor --    • Arduino Tutorial - Stepper Motor Control w...  

Stepper Motor with POT --    • Arduino Tutorial - Stepper Motor Control w...  

Stepper Motor with Bluetooth --    • Arduino Tutorial - stepper motor with driv...  

Servo Motor Control with Arduino --    • Arduino Tutorial - Servo Motor Control wit...  

----------------------------------------------------------------------------
Recommended Shopping Site -- https://goo.gl/GMS5uK
Arduino Starter Learning Kit -- https://goo.gl/7euGGy
Arduino Compatible Tools -- https://goo.gl/pR5FsF
Arduino Modules Boards -- https://goo.gl/bSCfwv
Professional Tools -- https://goo.gl/9Ym9MM
3D Printer and Tools -- https://goo.gl/rnN9At
Flash Deals for Electronic -- https://goo.gl/wvZAJG
Mobile Device Deals -- https://goo.gl/LzAwSu
----------------------------------------------------------------------------

Circuit

Servo motors have three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino or Genuino board. The ground wire is typically black or brown and should be connected to a ground pin on the board. The signal pin is typically yellow or orange and should be connected to pin 9 on the board.

The potentiometer should be wired so that its two outer pins are connected to power (+5V) and ground, and its middle pin is connected to analog input 0 on the board.

----------------------------------------------------------------------------

*** I recommend! You not connect directly the servo motor to arduino. I suggest you use external power to the servo.

SG90 Mini RC servo motors can be used. This can damage the Arduino MG996 instant high torque.

MG996 Stall Torque: 9.4kg / cm (4.8V) - 11 kg / cm (6.0V) and Operating voltage: 4.8 ~ 6.6v.

I wanted to tell in this tutorial; connections, code generation and motor control. So I did not give more details about the engine.

----------------------------------------------------------------------------

Get the Source Code --

----------------------------------------------------------------------------