VIFLY ShortSaver Smart Smoke Stopper Useless for Micro's or Faulty

Tested a Vifly Shortsaver i just received and just shorts out on 2 perfect quads. Also there is a 1A / 2A switch, which doesnt work on the one i received. The switch position closest to the Red XT30 wire is the 2A (2 Amp) setting and should keep a blue L.E.D. lit. The position closest to the edge is the 1A (1 Amp) setting. During this video as you can see it is in the 2A Position (closest to the XT30 Wire) and doesnt leave the blue L.E.D lit.

For the Armattan Tadpole it shorts out after a second and for the Vanta 2 it shorts out instantly.

There are 2 solder points on the back to bridge for S and N which adjusts the trip time from 3ms (short-circuit) and 10ms (over-current)
to 5ms (short-circuit) and 15ms (over-current) for bridging the "S" Pads
and 7ms (short-circuit) and 20ms (over-current) for bridging the "N" Pads.

I didn't bridge any and left it as is, as these settings shouldn't really be required for 2 / 2.5 Inch micro's. Plus it is already in shrink tube which you would have to cut away if you want to bridge the pads and no spare shrink tube is supplied.

Battery Used : Tattu 3S 450mAh

I also tested it on a Tattu 2S 450mAh with the same result.

Considering the 1A / 2A switch doesnt work at all, i know its already defective, but there must be much more wrong as it wont even start a 2 inch micro without shorting

All VTX settings are @ 25mW also.



My RotorBuilds Page:
https://rotorbuilds.com/profile/7995