Siemens iQ500 WM14T462NL - Service Mode

Demonstrating the Service Mode in the Siemens iQ500 WM14T462NL!

P:01 = Safety test - Only usable by BSH engineer as you need an special device for this test
P:02 = Automatic test cycle - Quickly tests all the components of the machine NOTE: During the last step of the test, the UNBALANCE SENSOR is switched OFF!!!
P:03 = Motor test - Tests the motor and 3D/3G Sensor. NOTE: The UNBALANCE SENSOR is switched OFF during this test!!!
P:04 = Water inlet test - Tests the water inlet valves and fills until overflow level is reached.
P:05 = Drain pump test - Tests the drain pump
P:06 = Heater test - Tests the wash water heater, heats for 30 minutes or until 85c is reached, whatever comes first
P:07 = Pressure switch test - Calibrates the pressure switch and tests it by filling the tub with water
P:08 = Turbidity sensor test (aquaSensor) - Tests the water turbidity sensor (aquaSensor). This machine doesn't have this sensor, that's why it got stuck in service mode after this test
P:09 = Flow meter test - Tests the flow meter by letting water go through it (about 5 litres)
P:14: Display test - Tests the display by illuminating all the LED's

Note:
All other P:xx have no function on these machines!

Enjoy!