Maidening the T1 Ranger and First Time on INAV

Finally jumped on the HeeWing Ranger hype train! This little plane was super easy to setup and really easy to fly, even for me being completely new to INAV (once I remembered to arm 😅).

Thanks to ‪@JohnCuppi‬ for helping me through setup and for the great camera work! (We may need a wind filter next the haha).

Model: HeeWing T1 Ranger (V1)
FC: Matek F411 WTE
VTX: Diatone Mama Ultra 1000
Receiver: HappyModel ep2 ExpressLRS
Camera: Foxeer Toothless 2 Starlight
Battery: GNB lithium-ion 3S 2500mah 12C

3D Prints (PETG unless otherwise noted)
Motor pods were from this forum post. You need to print one as is then a mirrored one for the other wing: https://www.rcgroups.com/forums/showt...
Rear hatch/vtx holder (or similar, there are many versions of this hatch): https://www.thingiverse.com/thing:548...
Rear vent/antenna holder: https://www.thingiverse.com/thing:527...
I used the GPS table in this for my GPS mount. I ended up printing it in TPU: https://www.thingiverse.com/thing:517...
Landing skids (TPU): https://www.thingiverse.com/thing:497...