Compustar Alarm & Remote Starter Installation Toyota Corolla

Installing a Compustar 2-way Alarm & Remote Starter on a 2014 Toyota Corolla. Installing wiring, hood pin, siren, OBDII connections for the ADS-BLADE-AL module, antenna, and programming the remotes.

Amazon Affiliate Links:
CS7900 Alarm+Starter: https://amzn.to/3gP3QYG
Blade AL: https://amzn.to/2WfRJvZ
ADS USB Blade AL Programming Cable: https://amzn.to/3fu78Ad
As an Amazon Associate I earn from qualifying purchases. If you make a purchase, thank you for supporting my channel!
For some models, ADS-HC may be the only option for remote start: https://amzn.to/44bgHfU , Always check compatibility first at https://www.idatalink.com/support .

How to Program:    • FIRSTECH ACADEMY - Blade & Controller...  
ADS-BLADE-AL Install Guides with Wiring Colors are here:
https://www.idatalink.com/product/pro...


⚠️ DISCLAIMER:
Use of the information in this video is solely at your own risk. The creator of this video assumes no liability for any property damage, injury or expenses incurred as a result of any of the information contained in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result.
The creator of this video makes no claims, promises or guarantees about the accuracy, completeness, or applicability of the procedures and instructions contained in this video.
Any injury, damage, or loss that might occur as a result of improper application, improper use of tools or equipment, or from the information contained in this video, is solely the responsibility of the user.

00:00 Intro
00:47 Removing Side Trim and Steering Wheel Trim
2:20 CM7000 Alarm Unit Overview and Blade Features
3:10 Wire Loop to Select Manual or Automatic Transmission
3:30 Temperature Sensor, Thermistor
3:45 Gray Connector Hookup, Parking Lights, Hood Pin, Siren, Ground when Running
4:16 Autolights Relay to Turn off Headlights using Ground when Running
4:41 Lights Switch at the Steering Wheel
4:58 Installing Hood Pin and Siren Wiring
6:08 Pulling Wire Through Firewall Rubber Grommet, Poking Grommet
7:05 Black Connector, CANH CANL SIL And RDA Wires
7:21 Removing OBD Port
7:46 RDA Wire Location
7:54 Low Current Wiring, Starter, Accessory, Ignition, +12V and Ground.
8:10 Ground Wire
8:21 Ignition Switch Connector
8:28 Antenna Location and Wiring
9:16 Program Blade
9:24 Compustar Remote Control Programming
10:03 Testing Hood Pin and Remote Start
10:24 Installing LED Light
10:58 Shock Sensor Location and Alarm Zip Tied