Jeep Cherokee XJ VM 2.5 TD Exhaust Manifold Build for the GT2871R Turbo

Now that I have the Chrysler Voyager Exhaust Manifold and the Ford Scorpio Inlet Manifold for the VM, I want to try and relocate the turbo and make a T25 manifold adapter. This should allow me to run a broader range of turbos that use T2 flanges. It should also make dealing with any maintenance issues much easier as the turbo will be located next to the engine. It could all be a waste of time but I quite enjoy tinkering around and I can always default back to the original setup if need be.
All I need now is to select a turbo charger and install it in episode 2.
Thanks for watching.

425 OHV Engine Manual - https://pdfcoffee.com/jeep25tdmotorvm...
VB180086 - http://www.invasionautoproducts.com/j...
VA180069 - http://www.invasionautoproducts.com/j...
https://www.americantechnology.co.uk/
EGR Delete - https://www.ebay.co.uk/itm/2231438389...

   / @workshoptowilderness  
Support me on Patreon -   / workshoptowilderness  
My Amazon Affiliate Store - https://www.amazon.com/shop/mcqbushcraft
Follow me on Instagram -   / workshopwildernessadventures  
Follow me on Facebook -   / workshop-wilderness-adventures-21275849708...  

Useful Links
Offroading in Sweden - http://www.swedishepa.se/Enjoying-nat...
Road, Trail and Terrain Laws - https://www.svmc.se/smc/SMCs-arbete--...
Driving Private Roads Sweden - http://www.swedishepa.se/Enjoying-nat...
Wikiloc Trails - https://www.wikiloc.com/trails/offroa...
Road Map - https://nvdb2012.trafikverket.se/SeTr...

Jeep Spec:
1999 Jeep Cherokee XJ 2.5TD RHD.
35x12.50r15 BFG KM3's with 15x8 3.75" backspacing (-19 offset).
Lift Front - RC 4.5" Coils and N2 Shocks (3" Coil Spacer).
Front Shock Bar Pin Eliminator.
Dana 30 High Pinion with Artec Industries Lower Control Arm Mounts with modified upper mount and modified Track Bar mount.
Front RC Control Arm Drop Bracket.
Ruff Stuff Short Arm Single Himes.
RC Extended Sway Bar Links.
Dana 30 Rock Crusher Diff Cover.
Ruff Stuff One Ton OTK Steering.
6" Lift Drop Pitman Arm.
Ruff Stuff Front and Center Frame Stiffeners.
Rear DIY Frame Stiffener and Rear Frame Tie in Kit.
6" x 2" Box Rocker replacement with Tube Slider.
Modified Factory Bumper with Side Sliders.
Rear Tow Hitch Tire Carrier that bolts into Rear Frame Tie in Kit.
Modified upper Shock Crossmember for Rear Shocks
Rear Axle Chrysler 8.25 29 Spline with modified High Clearance Shock Mounts.
Rear Shocks 6.5" Trailmasters.
Rear Leaf Springs 5.5" Rubicon Express
Rear RC Shackle Relocation Bracket.
Stainless Steel Braided Brake Lines front and back.
Warrior 9500lb Winch.
Front Bumper - https://www.ebay.co.uk/itm/Jeep-Chero...