Feedback and Feed Forward Control | Basics of instrumentation & control

You will learn the basics of instrumentation and control. What is a control loop and its components? Also, you will learn feedback and feedforward control strategies with their advantages and disadvantages.

📢 If you find my content helpful, please don't forget to subscribe to my channel https://bit.ly/3b6wuV9 🔔.

If you want ❤️ to learn Aspen HYSYS from very basic, then check the following links:

Tutorial # 1
Getting started with Aspen HYSYS
   • Getting started with Aspen HYSYS  

Tutorial # 2
Bubble point, Dew point and Phase diagram calculations
   • Bubble Point, Dew Point, Phase Diagra...  

Tutorial # 3
Flash calculations in HYSYS
   • Flash Calculations in HYSYS  

Tutorial # 4
Sensible and latent heat and generation of saturated steam table in Aspen HYSYS
   • Sensible and latent heat  and generat...  

Tutorial # 5
Centrifugal pump sizing and selection in six easy steps
   • Centrifugal pump sizing and selection...  

Tutorial # 6
Pump power and efficiency calculations in HYSYS
   • Pump power and efficiency calculation...  

Tutorial # 7
Pump performance curves generation and rating in HYSYS
   • Pump performance curves generation an...  

Tutorial # 8
Simulation of Compressor and Turbine in Aspen HYSYS
   • Simulation of Compressor and Turbine ...  

Tutorial # 9
Compressor Surge Analysis in Aspen HYSYS
   • Compressor Surge Analysis  in Aspen H...  

Tutorial # 10
Pipe Sizing, Pressure Drop Calculation, Use of Adjust Function in HYSYS
   • Pipe Sizing, Pressure Drop Calculatio...  

Tutorial # 11
How to use case study tool and generate vapor pressure curve for Propane in HYSYS.
   • How to use case study tool and genera...  

Tutorial # 12
Crude oil three-phase separation | Decanter simulation in HYSYS
   • Crude oil three phase separation | De...  

#FeedbackControl #PIDController #FeedforwardControl

0:00 Introduction
0:46 Learning objectives
1:45 The control loop
6:40 Definitions
10:03 Error explanation
13:38 Control algorithm
20:35 Feed back control