Zero 2 Fightstick - Installing Passthroughs

In this follow up series to the original Zero to Fightstick, you'll again see how to build/assemble your very own arcade controls from the ground up. If you've wanted to know how to build your own stick but weren't sure how, this is meant to be your resource. This time you'll learn how to build an even more advanced setup, if that's your thing, or you can use just the information you need to build the setup of your choice.

In this episode you'll learn about how to install both RJ45 and USB-C passthroughs, as well as the Neutrik SCCD-W spring door. I use two blank D-Series keystone plates, a CAT6 RJ45 passthrough, and a USB-C passthrough. The passthrough simply allows you to run an internal cable to your control board (PCB) and then connect a cable on the outside, so you can unplug the external cable when you're done.

Music: "Sweet Hazelnut" by John Montoya

No Patreon, etc. (yet) but if you'd like to support me, you can always give https://saturnforge.com a visit where you'll find my store with all the stuff I don't want.