BBBs02e15 | Adjusting Needle Jet by Moving the E Clip | Cutting Carburettor Slide Spring | XVS650

Описание к видео BBBs02e15 | Adjusting Needle Jet by Moving the E Clip | Cutting Carburettor Slide Spring | XVS650

After adding a K&N filter and mikuni # 120 main jets last week for more top end. In this episode we lift the needle jet by dropping the E clip on the needle one slot from the third slot from the blunt end to the fourth slot from the blunt end to richen or fatten the mixture. We clip two loops off the CV carb slide to allow it to rise and fall at a quicker rate which gives better throttle response. We also adjust the air fuel mixture screw from a stock 2.5 turns out to 3.5 turns out to richen or make the mixture more rich. We then Test ride the combination a find much better performance through the middle range.

Комментарии

Информация по комментариям в разработке

Похожие видео