2011 Jeep Grand Cherokee - CV Axle Remove and Replace - Passenger Side

This is an edited full length video going through step-by-step what is needed to remove and replace the passenger side CV axle on your Jeep Grand Cherokee. The job took about 2.5 hours because of having to cut the stabilizing links off and of course shooting the video. I apologize in advance for some of the air blowing noise, but it was a very warm day and I needed some air movement. :) Take a look and perhaps this will help you with your project! Cheers!

Timestamps
00:00 Start
00:16 Introduction/What are we working on?
00:28 Wheel/Tire removal
00:50 Summary of steps to do
01:28 Raise drive side of vehicle
01:43 Remove brake caliper assembly
02:16 Axle nut removal
03:14 Rotor removal
03:40 Wheel hub tips
03:55 Upper control arm & ball joint loosening
05:30 Outer tie rod removal
06:08 Stabilizer linkage struggle
07:21 Lower strut bolt & nut
08:58 Finish loosening upper ball joint
09:37 CV Axle & Wheel hub separation
10:52 CV Axle & Differential separation
12:58 CV removed from vehicle
13:32 Old CV axle look-over
14:38 Caution on differential seal
15:12 Finish cutting off stabilizer links
16:20 Install new CV axle
17:40 Reinstall axle seal
17:57 New CV into wheel hub
18:44 Reconnect upper ball joint
19:16 Reinstall verbal walk-thru (what's next!)
20:09 Torque specs

How can we make our videos better? What other content would you like to see?
[email protected]