How to Engrave Silicone using the xTool F1 Laser

Subscribe to my channel:
   / @karleyhall  

If you'd like to buy any of the items shown in this tutorial, check out the links below. Some links are affiliate links. By clicking on these links I may earn a small commission at no cost to you. Some products may have been provided to me by vendors, however, all opinions and reviews are strictly my own.

Settings:
Laser Type: Blue Light
Power: 80%
Speed: 200 mm/s
Passes: 3
Lines per cm: 120
Engraving mode: Bi-directional

Additional Helpful Tutorials:
✔️ How to Set up xTool F1:    • BEGINNER: How to Set Up and Use xTool F1  

Shop Here for All Products:

✔️ xTool f1: https://amzn.to/4cV6jhl

✔️ xTool f1: https://www.xtool.com/products/xtool-...

✔️ Watch Bands: https://amzn.to/4diGh7N

✔️ Ciera Dingbat Font: https://www.silhouettedesignstore.com...




Shop My Cricut Faves Here: https://www.amazon.com/shop/karley.hall

Shop My Favorite Vinyl Here: https://www.143vinyl.com/starcraft-hd...
*use code KARLEY

Website: https://karleyhall.com/
Youtube:    / @karleyhall  
Instagram:   / karley.hall  
Facebook:   / karleyhallcreative  
Facebook Group:   / cricutcraftswithkarley  

*Disclaimers

Some links above are affiliate links. By clicking on these links I may earn a small commission at no cost to you. Some products may have been provided to me by vendors, however, all opinions and reviews are strictly my own.


Karley Hall will not be liable to You or anyone else for any decision made or action taken in reliance on the information given by this video or for any consequential, special or similar damages, even if advised of the possibility of such damages.