How to Fix a Hole in Your Boat DIY (Below the Waterline)

Learn how to fill a hole in your boat. If your fiberglass hull has screw holes, fiberglass damage, a hole under the water line, or anything like that, this video shows you how to do a proper hole repair so it wont leak and your boat wont sink.

Marine Thickened Epoxy: https://amzn.to/3fnCdr1
Drill Bit Set: https://amzn.to/34Troef
Pipe Cleaner Kit: https://amzn.to/3zWRuIN
Acetone: https://amzn.to/3GtI6Pm
Canned Compressed Air: https://amzn.to/3qqOD7N
Full Face Respirator: https://amzn.to/3qtVEVk
P100 Filters: https://amzn.to/33uQejT


0:00 How to repair a hole in your boat intro
0:57 Tools and products to fix the hole
1:51 1st Step (drill out the hole in the fiberglass)
3:07 What is a bevel and why it's important
4:17 How to add a bevel
4:57 2nd Step (clean out the hole)
6:56 3rd Step (use epoxy to fill the hole)
10:01 How to install a through hull transducer
10:34 Sea trial the boat and look for leaks

Disclaimer:
Due to factors beyond the control of ChrisFish, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFish assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFish recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFish, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFish.