KitchenAid Dishwasher- How to Reset

Demonstrating how reset a KitchenAid Dishwasher. If you need to reset your KitchenAid dishwasher, here's a general guide. Keep in mind that specific models might have slightly different procedures, so it's a good idea to consult your dishwasher's manual for model-specific instructions:

Hard Reset:

Turn Off and Unplug:

Make sure the dishwasher is powered off. If it's hardwired, you may need to turn off the circuit breaker that supplies power to the dishwasher. If it's plugged in, unplug it from the electrical outlet.
Wait a Few Minutes:

Allow the dishwasher to remain without power for a few minutes. This helps to reset the control board.
Restore Power:

Plug the dishwasher back in or turn the circuit breaker back on.
Turn On:

Turn on the dishwasher and see if the reset has resolved the issue.
Control Panel Reset:

Locate Control Panel:

On the front of the dishwasher, find the control panel. The location can vary depending on the model.
Press High-Temp and Start/Resume:

Press the "High-Temp Wash" and "Start/Resume" buttons simultaneously and hold them down for about 3 seconds.
Wait for LED Display:

Some models have an LED display. Wait for the display to show "00" or a similar code.
Close Door:

Close the dishwasher door and wait for a minute or two.
Open Door and Press Cancel:

Open the door, then press the "Cancel" button.
Run a Test Cycle:

Run a short test cycle to check if the reset resolved the issue.
Remember to refer to your dishwasher's manual for model-specific instructions. If the problem persists or if you're unsure about the reset process, it's recommended to contact KitchenAid customer support or a qualified technician for assistance.

If you have the model number of your dishwasher, I can try to provide more precise instructions.