Скачать или смотреть $5 DIY Filament Runout Encoder! Why buy one?

This is an open source Filament Runout Encoder which detects filament jams in addition to filament runout similar (and I think better) than the BigTreeTech one. This will run you about $5 to make. You only need a few parts for this project most of which can be found in your shop already. The project will work with Ender 3, CR-10, LayerFused X301, Anet and many more 3D Printer bands. You simply need to be able to compile your firmware and have a free pin for the encoder. This project covers setup of the runout encoder in Marlin but can be used with other firmware that detect filament runout by encoder pulses. Upgrade your filament detection to a smart filament sensor today!

0:00 - Introduction
3:06 - Building the encoder
8:39 - Firmware Setup
10:54 - Testing
12:21 - Wrap Up

The project can be downloaded on Thangs here https://social.thangs.com/m/54307

Bill of Materials
1 - 608 Skateboard Bearing : https://amzn.to/3oyXzEV
2 - M3 8MM Screws : https://amzn.to/3bgc8Jq
1 - M3 6mm Screw: https://amzn.to/3bgc8Jq
2 - M10 Press Fit Fittings: https://amzn.to/390PWQI
1 - Small Rubber Band
1 - Optical Filament Sensor: https://amzn.to/35jx9PP
8 - 6mm x 3mm Magnets: https://amzn.to/2MFK4oK

Some short lengths of bowden depending on your build
https://amzn.to/393qbzo

Please mash that like button if you enjoyed this video and leave your comments below!

Please consider helping support the channel through Patreon so we can continue to develop new and exciting content.
  / makersmashup  

Follow my Thangs.com profile to find all the models I make!
https://thangs.com/user/Makers%20Mash...

Chat with us and other makers on our Discord:   / discord  

Follow us on Twitter:   / makersmashup  
Instagram:   / makers_mashup  
Visit our website www.MakersMashup.com

MakersMashup Uses TubeBuddy as their YouTube assistant! https://www.tubebuddy.com/MakersMashup