How to Install Power Beyond Kit on John Deere 6400 Tractor

VIDEO CORRECTION: INSERT DIME DISC IN TRACTOR'S STACK PORT (NOT IN POWER BEYOND BLOCK'S PORT AS SHOWN IN VIDEO), AND INSTALL POWER BEYOND BLOCK WITH O-RING AGAINST TRACTOR'S STACK (SCV).

This video shows how to install the power beyond kit on the John Deere 6400 tractor. The same power beyond kit fits the John Deere 6110, 6120, 6200, 6210, 6215, 6220, 6300, 6310, 6320, 6400, 6405, 6410, 6415, and 6420 tractors. The PBY block kit includes the block, two sets of studs (one set is 175 mm, and the other set is 220 mm), and the dime disc. This kit is tapping into the tractor's hydraulics so the rear remotes are left free. The block has a pressure port, and return port, and a load sense port. These ports supply hoses carrying oil to and from the loader control valve, thus leaving the rear remotes free on the tractor.

The steps for installing the manifold block kit are listed below:
1. Remove triangular cap.
2. Remove studs one at at time, and replace each stud that you pull out with the new long stud before pulling the next stud out. You don't want to pull all three studs out at the same time, because if you do, the rear remote blocks will fall apart and it will be very difficult to put the longer studs in. Whether you need the shorter 175 mm studs or the longer 220 mm studs depends on how many remote blocks you have on your 6000 series John Deere tractor. In this video, we have 3 blocks so we are using the 175 mm bolts.
3. Tighten new studs and discard old studs.
4. Place power beyond block on the studs.
5. Insert dime disc into slot on PBY block.
6. Replace the triangle cap and tighten it on with nuts.

Purchase John Deere 6000 series power beyond block kit here:
https://www.shortlineparts.com/pby-ki...