How To Make A Generator Exhaust Extension Kit

In this video, I show you how to make a generator exhaust extension kit. You can extend your generator's exhaust by following these easy DIY steps. There is no welding involved and all of the parts can be easily found at your local home improvement store and amazon. This allows you to get the exhaust fumes out of your generator enclosure, garage, RV, etc. In this video I was creating an exhaust extension for a Cat RP12000E generator.

Products Used In The Video:
Exhaust Flex Pipe: https://amzn.to/30rLzen
Gasket Maker (rated up to 700 degrees intermittent): https://amzn.to/34hJLGz
1 Inch Floor Flange: Found at your local home improvement store
1 Inch Threaded Galvanized Steel Pipe: Found at your local home improvement store

Tools Used:
Angle Grinder: https://amzn.to/3qV0JEt
Drill: https://https://amzn.to/3gR8B53
Drill Bit Set: https://amzn.to/308of4Q
Safety Goggles: https://amzn.to/30afFTb

DISCLAIMER: Thank you for watching and for subscribing. You can support the channel at no cost to you by using one of the above affiliate links. This helps support the channel for new content.

Blessings,
Adam

How To Home assumes no liability for damage or injury. How To Home highly recommends using proper safety procedures and professionals when needed. Our content is for entertainment purposes only. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not How To Home. How To Home will not be held liable for any negligent or accidental damage or injury resulting from equipment, tools, electrical, fire, electronics or any items contained in this video. Attempt projects and repairs at your own risk.