P38 Range Rover - EAS Compressor new thermal switch

EAS Compressor suddenly wouldn't turn on.

I jumped RL20 to make compressor run, and prove it still works. I go through the steps to replace thermal switch inside the compressor, (which has gone open circuit and must be replaced).

You could drill the holes bigger and place new rivets in but I just used a thin pilot hole and very small screws to hold the electronic board back in place.
For reinstall of casing:
I place strands of wire behind the brushes on the circuit board, to keep them open. I place compressor housing down onto the lid and pull these wires out once housing is almost all the way down. Footage of this at end of video is from just before I did the actual thermal switch job.
Source of 125c thermal Switches:
http://www.digikey.com.au/en/products/deta...
https://au.mouser.com/ProductDetail/AIRPAX...