Live Hot Wheels How To Drill And Tap Session

Come check out how I drill and tap my Hot Wheels Cars.
Products used in video
Drill bits are from Home Depot any brand works the sizes are 5/32 for removing the rivet. Then I go in with a 2/56 drill bit and drill the post. I go about a 1/2 CM deep or a little less on the shorter post which you will need to use a shorter screw as well. The tap kit I use is from Brightvision. You can visit them at brightvisionwheels.com side note these are not a sponsor. I use a Ryobi Drill as well which was bought at Home Depot.
Appreciate yall coming out and hanging out for a drill and tap session. Leave questions down below and I will be sure to answer them for you. Thanks again and don't forget to check out some of my recent customs.