Jeep XJ Clutch Install and a Noisy AX15 and NP231

After some insane vibrations on the Jeep I had no choice but to pull the drive train for inspection. The transmission and t-case have done over 20 years of service with pretty low mileage but large tires and a high suspension lift. My first thoughts were the clutch but sadly the transmission itself had some excessive wear that would require a rebuild if used again.
I was lucky that my spare engine came with a low mileage AX15 and Np231J that have seen no offroad uses and were largely unused for many years. The condition of both were much better and with the new clutch and refaced flywheel have made a huge difference!

   / @workshoptowilderness  
Support me on Patreon -   / workshoptowilderness  
GRABmeGEAR - https://www.grabmegear.com/
My Amazon Affiliate Store - https://www.amazon.com/shop/mcqbushcraft
Follow me on Instagram -   / workshopwildernessadventures  
Follow me on Facebook -   / workshop-wilderness-adventures-21275849708...  

Useful Links
Offroading in Sweden - http://www.swedishepa.se/Enjoying-nat...
Road, Trail and Terrain Laws - https://www.svmc.se/smc/SMCs-arbete--...
Driving Private Roads Sweden - http://www.swedishepa.se/Enjoying-nat...
Wikiloc Trails - https://www.wikiloc.com/trails/offroa...
Road Map - https://nvdb2012.trafikverket.se/SeTr...

Jeep Spec:
1999 Jeep Cherokee XJ 2.5TD RHD.
Summer Tire - 35x12.50r15 BFG KM3's with 15x8 3.75" backspacing (-19 offset).
Winter Tire - Cooper Discoverer ST MAXX Por Studded 35x12.50r15 BFG KM3's with 15x8 3.75" backspacing (-19 offset).
Lift Front - RC 4.5" Coils and N2 Shocks (3" Coil Spacer).
Front Shock Bar Pin Eliminator.
Dana 30 High Pinion with Artec Industries Lower Control Arm Mounts with modified upper mount and modified Track Bar mount.
Front RC Control Arm Drop Bracket.
Ruff Stuff Short Arm Single Himes.
RC Extended Sway Bar Links.
Dana 30 Rock Crusher Diff Cover.
Ruff Stuff One Ton OTK Steering.
6" Lift Drop Pitman Arm.
Ruff Stuff Front and Center Frame Stiffeners.
Rear DIY Frame Stiffener and Rear Frame Tie in Kit.
6" x 2" Box Rocker replacement with Tube Slider.
Modified Factory Bumper with Side Sliders.
Rear Tow Hitch Tire Carrier that bolts into Rear Frame Tie in Kit.
Modified upper Shock Crossmember for Rear Shocks
Rear Axle Chrysler 8.25 29 Spline with modified High Clearance Shock Mounts.
Rear Shocks 6.5" Trailmasters.
Rear Leaf Springs 5.5" Rubicon Express
Rear RC Shackle Relocation Bracket.
Stainless Steel Braided Brake Lines front and back.
Warrior 9500lb Winch.
Front Bumper - Ebay Custom Made.