PLASMA 01: The introduction and build kickoff ! The RoboCNC Plasma Cutter

[ RoboCNC Frees & Graveerwerk http://www.RoboCNC.nl/ ]
[ Instagram: https://goo.gl/fNfZGk ]
[ FaceBook: https://goo.gl/D32sQa ]
DIY CNC Plasma Build - RoboCNC Plasma

Every build starts small, today the first steps into the DIY CNC Plasma table build by RoboCNC.
First a small introduction in plasma and plasma cutters like my new Hypertherm Powermax 45XP, the Duramax Hypertherm machine torch, and an anti-collision plasma torch holder. The Anti-Coalition holder, combine with inductive NPN sensors will signal the MyPlasma CNC Controller to stop the machine. But first let me give you a brief overview on what plasma actually is.

00:00 Intro
00:53 What is plasma?
02:00 The inverter that creates plasma
06:17 Plasma torches
09:22 Anti-collision plasma torch holder
12:13 Selecting the right inductive sensor for the job
25:09 Thanks for watching


Like The Video? Thumbs up and subscriptions are much appreciated
And don’t forget to follow up on social media like Facebook Google+ Instagram or twitter.

Music:
None

Sponsored by:
None

Products used in this video:
Hypertherm plasma : https://shorturl.at/bmPS0
Plasma Torches : https://shorturl.at/aptRS
Anti-Coalition holder : https://amzn.to/3PJK18O
Inductive sensors : https://amzn.to/49i1NXN

Camera : https://amzn.to/49gwzBf
Video Light : https://amzn.to/42SzCxi + https://amzn.to/42SwDEI
Panel lights : https://amzn.to/3V8HAAz
RGB lights : https://amzn.to/49LKcrM
Microphone : https://amzn.to/3uTPB1c
Lav mic recorder : https://amzn.to/49qssTl