Land Rover Discovery 3 DEACTIVATE BUILD MODE & RE-ENABLE EAS - GAP iiDTool

In this video I show you how you can deactivate build mode (Transport mode) and how you Re-enable EAS using a GAP iidtool BT. This is what you need to do after replacing the air reservoir or have run any of the deflate procedures.

Disclaimer: I'm not a trained mechanic. The air suspension can be dangerous to work on if done wrong due to highly compressed air.

FAULT CODE: C1A00-53 (AF) Control module - System programming failure - deactivated
FAULT CODE: C1A00-53 (AF) Control module - System programming failure - missing calibration

Initial fault code for the reservoir replacement.
FAULT CODE: C1A20-64 (AF) Pressure increases too slow when filling reservoir - Algorithm based failure - signal plausibility failure
If you have any questions feel free to write a comment and I will respond as soon as possible.

Remember to support the channel by subcribing and support it even more by becomming a Land Rover Drive Patreon.
PATREON:   / landroverdrive  

Affiliate links:
iiDTOOL BT UK-ebay link:
https://ebay.us/b7uLCO

iiDTOOL BT US-ebay link:
https://ebay.us/W4sC8W

JETBOIL UK:
https://ebay.us/6b2Ybp

Edited in Adobe Premier Pro by Simon Schybaj Mastermo - SIMON FILM STUDIO MASTERMO

"This video details contains affiliate links for which I may be compensated for."
Some of the links above are affiliate links, where I earn a small commission if you click on the link and purchase an item. You are not obligated to do so, but it does help fund these videos in hopes of bringing value to you!

For sponsorship, product reviews, and collaboration, you can email me here: [email protected]

ig and fb: @landroverdrive