RNTF 21 inch Mark 2 torpedo, 1915

This 21 inch (533mm) torpedo was used by the Royal Navy from 1911 through to 1918 (and beyond). Designed and built by the Royal Naval Torpedo Factory, the Mark 2 (Mark II) was operational in 1911 and was modified several time (this is the Mod 5 version, about 1915) before being superseded by 21 inch Mk 4 (Mark IV) torpedo by 1918.
It is a wet - heater design with fuel being burnt in a stream of air before being cooled by a spray of water (which then boils to steam - adding to the volume of gasses delivered to the engine). The 4-cylinder Brotherhood engine was capable of being fired from a submarine’s bow torpedo tube, from Battleship side tubes or from above-water launcher mountings on smaller warships. By adjusting the fuel and air flow rates, the Mk 2 could be set to run fast (44.5 knots) to a range of 4,500 yards, or out to 18,500 yards at 19 knots.
The torpedo was was designed to be launched from a flooded tube. Once the air start valve is opened, the air in the pressure vessel is first reduced to a steady 350 psi and then fed to the engine to turn it over and clear the water in the cylinders and crank case. The pistons have a vent hole that connects the cylinder head and the crank case. The vent hole is closed during the power stroke but open during the return stroke - allowing any water to vent into the crank case. However, the fuel is not ignited until the engine has been cleared of water (underwater launch) or has had time to enter the water for an above-water launch (the wet-heater Generator and Engine need to be cooled by sea water), so the ignition cartridges are not fired until the engine has rotated a preset number of revolutions using the cold air - this is the Ignition Delay - 4-5 revs for an underwater launch and 20-30 revs for an above water launch. When the fuel is then ignited, the engine accelerates to full power.
Fuel was Shale oil - a light oil with a flashpoint of 71 deg C.

Mark II torpedoes could be launched with a Gyro Angle setting. When fired from a beam tube or above-water launcher, the torpedo would then turn through the required Gyro Angle - which meant that the torpedo course was not dependent on the ship’s course. Gyro Angle could be set in 5 degree steps, Left or Right.

Sources:
CB523 Handbook for RNTF Torpedoes, 18inch Marks VII to VII****, 21inch Marks II to IV*, 1918
CB243 Manual of Gyroscopes for Torpedoes, 1916

If you appreciate my animations, please consider supporting me as a Patron through www.Patreon.com/vbbsmyt. This will help me research other complex, iconic devices, especially WW1 weapons and guns.

This animation was made using Cinema 4D. Background music is ‘Your Suggestions’ by Unicorn Heads.