ESP32 + PCB Antenna Hardware Design Tutorial - Phil's Lab #90

How to design custom hardware using ESP32 MCUs (ESP32-C3, NOT pre-made modules!) and PCB antennas (inverted F, in this case). PCBs by PCBWay https://www.pcbway.com

Showing examples and real, working hardware (WiFi scan test), a full schematic walkthrough, and a PCB design walkthrough. Final test using Arduino IDE & ESP32 expansion.

Many more ESP32 firmware & hardware tutorial videos to come!

[SUPPORT]
Free trial of Altium Designer: https://www.altium.com/yt/philslab

PCBs manufactured and assembled by PCBWay: https://www.pcbway.com

Patreon:   / phils94  

Mixed-signal hardware design course: https://phils-lab-shop.fedevel.education

Advanced Hardware Design Course Survey
https://forms.gle/X4jwvtZeJ1jTXh7r9

[GIT]
https://github.com/pms67/ESP32-USB-Do...

[LINKS]
Instagram:   / philslabyt  

ESP32 Hardware Design Guidelines: https://www.espressif.com/sites/defau...
ESP32-C3 Datasheet: https://www.espressif.com/sites/defau...
TI PCB Antenna Application Note: https://www.ti.com/lit/an/swra117d/sw...

[TIMESTAMPS]
00:00 Introduction

00:29 Altium Designer Free Trial
00:49 PCBWay

01:19 ESP32-C3 and Hardware Overview
04:28 ESP32 Hardware Design Guidelines

06:14 Schematic - ESP32-C3 Power Pins
07:26 Schematic - Crystal
08:50 Schematic - Chip Enabled (Reset)
09:16 Schematic - SPI FLASH
10:21 Schematic - USB and Power
12:29 Schematic - UART, Sensor
13:26 Schematic - Bootmode Select
14:10 Schematic - PCB Antenna
17:43 Schematic - RF Matching Network

22:15 PCB - Overview & Stack-Up
23:47 PCB - Controlled Impedance
24:10 PCB - General Guidelines, Decoupling
25:54 PCB - Antenna and Matching Network

29:22 WiFi Test (Arduino IDE)

33:37 Outro