BMW F30 328i COOLANT FLUSH & BLEED

This video will show how to drain then top off your coolant in your F30 328i.
For this you will need the following tools and BMW parts:

BMW coolant: https://rover.ebay.com/rover/1/711-53...
1 Gallon Distilled Water: Local store
Pick tools: https://rover.ebay.com/rover/1/711-53...
Various sockets: Local store or Harbor Freight
Bucket: Local store
_____________________________________________________________

The F30 has 3 bleeding screws and you can find information on the process directly from BMW below:

Drain + Top Off Coolant Process: https://www.newtis.info/tisv2/a/en/f3...

N20 Coolant Amount: https://www.newtis.info/tisv2/a/en/f3...

Shop Bleeding Procedure: https://www.newtis.info/tisv2/a/en/f3...

More BMW How To's: https://www.newtis.info/tisv2/a/en/f3...

F30 n20 Fluid Specs: http://www.automobile-catalog.com/oil...

F30 n20 Specs: https://www.amsoil.com/AmsoilGarage/i...
_____________________________________________________________

F30 Bleeding Instructions:
1. Fill cooling system using the vacuum filling device, after completing the filling procedure, remove the vacuum filling device.
2. Overfill the expansion tank (to below the tank ventilation line).
3 Open the bleeder screw (1) with the expansion tank open.
4 Open the bleeder screw on transmission oil cooler (2) until coolant emerges without bubbles and then close it again. Tightening torque 17 10 8AZ.
5. Open the bleeder screw on radiator return hose (3) until coolant emerges without bubbles and then close it again. Tightening torque 17 10 8AZ.
6. Close bleeder screw on expansion tank Tightening torque 17 10 8AZ.
7. Massage coolant hoses (supply and return radiator).
8. Connect battery charger.
9. Switch on ignition and low-beam headlight. Switch on the low-beam headlights to perform the bleeding procedure. If the low-beam headlights are not switched on, the ignition (Terminal 15) will switch off automatically after a certain period of time and interrupt the bleeding procedure.
10. FES (driving experience switch) must not be in ECO PRO!
11. Set heater to maximum temperature and turn blower down to lowest speed.
12. Press accelerator pedal for 10 seconds to floor. Engine must not be started.
13. The bleeding procedure is started when the accelerator pedal is pressed and takes approx. 12 minutes. (Electric coolant pump was activated and shuts down automatically after approx. 12 min).
14. Then adjust filling level in coolant expansion tank to maximum.
15. Check cooling system for watertightness.
16. Close coolant expansion tank.
17. After the bleeding procedure, let the engine run until it is warm and the electric fan starts running.
18. If cooling system bleeding must be carried out again (e.g. if the cooling system is leaking), allow the Digital Motor Electronics to drop completely (remove the ignition key for approximately 3 min), then repeat from Section 3.
_____________________________________________________________
Song: Joakim Karud - Ocean (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link:    • Joakim Karud - Ocean (Vlog No Copyrig...