How To Connect Two Pieces Of Gutter With Gutter Splice. Overlap + Gutter Installation On Metal Roof

Learn How To Connect Two Pieces Of Gutter With Gutter Splice. Gutter Installation Video That Shows How To Overlap A Gutter On A Metal Roof.

If you have a gutter that is longer about twenty feet then you will have to overlap the gutter with a gutter splice. It's a simple installation that requires a small piece of gutter splice to be installed where the two pieces of gutter meet.


If you already have not purchased your metal roofing panels give us a chance to bid your job. Save 15% to 50% with our manufacturer direct pricing and great customer service. Inexpensive delivery anywhere within the USA

00:00 How to connect two pieces of gutter with gutter splice
00:19 How to splice a gutter on a metal roof
00:29 How to overlap gutters
01:00 How to sealing a gutter splice
01:12 How to overlap gutter splice
01:35 How to fasten gutter splice


Visit Our WEBSITE
https://bit.ly/wsmr-website

Visit our LEARNING CENTER
http://bit.ly/learning-center-wsmr


Gutter Splice Installation
1. If your gutter is being installed on a long stretch of roof, chances are you will need to join two gutter sections together. To do this:
2. Use a 12-inch gutter splice, and install it on the outside where the two gutter sections meet.
3. Place the splice in the middle, six inches from each section.
4. Using the gutter splice as a guide, make an outline six inches from the end of your gutter.
5. Make an additional outline three inches from the end, and apply silicone sealant along this outline.
6. Position the gutter splice in position by aligning it with the six-inch outline, and temporarily secure it using clamps.
7. Measure three inches from the gutter splice edge. This is where your silicone sealant is located.
8. Pre-drill three holes and install three rivets on both ends of the gutter splice
9. Pre-drill two holes on the lower end of the gutter where you will install two more rivets.
10. Fasten the gutter section to your roof using pancake screws 12 inches on center.
11. Prepare the adjacent gutter piece by applying sealant one inch from the edge.
12. Drop the gutter into the splice, leaving a quarter-inch gap between the two sections to allow for expansion.
13. Fasten the second section of gutter with pancake screws 12 inches on center.
14. Place a rivet on the top section of the gutter splice on the newly attached section of gutter, and apply sealant along the inner seams and all interior rivets.



FOLLOW US ON SOCIAL MEDIA:

FACEBOOK: https://bit.ly/facebook-wsmr
INSTAGRAM: https://bit.ly/instagram-wsmr
TWITTER: https://bit.ly/twitter-wsmr
LINKEDIN: https://bit.ly/linkinin-wsmr
HOUZZ: https://bit.ly/houzz-wsmr
PINTEREST: https://bit.ly/pinterest-wsmr
YOUTUBE: https://bit.ly/youtube-wsmr