How to program Hitec D series servos with the DPC-11 in 13 minutes - D645MW

Split-screen! I hope to save you some time when learning exactly how the DPC-11 works and EXACTLY how the D-Series servos are programmed with both parameters and center/end points.

Quick note: the number value when setting your EPA...from my rough calculations, it APPEARS to be about 23 "units" per degree. For example, when I want to program a servo for 45 degrees travel each way, I set the center point, and then add or subtract 1035 from that value to achieve very close to 45 degrees. This is rough...not exact...but how I calculate.

0:00 Intro
1:06 Connection to Computer
2:22 Overview of D-Series Options
4:53 Programming EPAs
6:59 Save a Config
7:45 Change Parameters
9:15 Program Servo in a Model (Flap Servo)

DPC-11 Servo Programming Interface - https://bit.ly/3LbY6IC
DPC-11 Manual - https://bit.ly/3sc7naU
D645MW 32-Bit, High Torque, Metal Gear Servo - https://bit.ly/3AT5IuJ