How to program Hitec HSB BRUSHLESS servos with the DPC-11 in 15 minutes - D9380

Split-screen! I hope to save you some time when learning exactly how the DPC-11 works and EXACTLY how the HSB Brushless servos are programmed with both parameters and center/end points.

Remember two things:
The configuration is not written to the servo until you hit the "Write All" button. Even if you save the config to a file!
When setting end points, the servo WILL rotate 34 degrees from where you've set the new center, in the direction you're setting. BE CAREFULL when programming the servo in a model and connected to a control surface!


0:00 Intro
1:21 Connection to Computer
2:25 Overview of HSB Options
4:30 Reset to Default
5:01 Importance of "Write All"
7:05 Set EPAs
11:24 How the "Read Servo" button works

DPC-11 Servo Programming Interface - https://bit.ly/3LbY6IC
DPC-11 Manual - https://bit.ly/3sc7naU
HSB-9380TH Ultra Torque, Brushless, Titanium Gear Servo - https://bit.ly/3oEVqcB