Скачать или смотреть Ep. 14 - YT624EJ M.S. - Auger Inspection and Wormcase Rebuild

00:00 Start
01:40 Manual Walkthrough
02:30 Auger Removal
06:15 Wormcase Disassembly
09:21 Wormcase Bearings and Seals
29:00 Wormcase Installation
44:00 Auger Installation
46:00 Wormcase Pressure/Vacuum Test
49:00 Wormcase Oil Filling


In this video we will look at how to remove and re-install the auger, and also how to perform a rebuild on the wormcase between the auger drive shaft and the auger shaft. Upon inspection of the worm gear wheel, the wear was deemed excessive and the wheel was replaced and the Yamaha recommended oil of 10w30 was swapped out for SAE 90 oil.

See here for key clearances and torque values.

Bearing Housing Bolt (qty 6) Torques: 11 N-m = 97 in-lbs
Auger Shaft End Bolts Torques: 20 N-m = 177 in-lbs
Shear Bolt Torques: 10 N-m = 89 in-lbs
Wormcase Drain and Fill Bolts: 16 N-m = 142 in-lbs
Wormcase Bolts (qty 6) Torques: 13 N-m = 115 in-lbs (Book recommends 12 & 16 N-m but 16 N-m not advised!)
Wormcase Stay Bolts (qty 4): 23 N-M = 204 in-lbs

As for parts:

Auger end bearings: Qty 2 6203RS rubber shielded
Wormcase auger bearings: Qty 2 6004 open
Wormcase auger drive shaft bearings bearings: Qty 1 6201 open and Qty 1 6004 open
Wormcase auger seals: Qty 2 SD 20 30 7-2
Wormcase auger drive shaft seal: Qty 1 SD 20 42 8