Replacing Hall Effect Device Part 2

Описание к видео Replacing Hall Effect Device Part 2

In this video I reassemble the "bean can" complete with new Hall Effect device. As you will see, half way through I had to remove the trigger assembly again in order to retrieve a bob weight spring that had come off and fallen into the works. So some of the assembly continuity is lost, but I don't think it causes too much confusion.
Fitting to the bike and subsequent timing are not covered, you can see how I do that in other videos in the maintenance playlist if you want to. But there is a short clip at the end showing the initial start-up with the rebuilt can installed.

Комментарии

Информация по комментариям в разработке

Похожие видео