Easiest Way to Repair a Kinetico Water Softener

Kinetico level one, has the most complex parts. This Kinetico level has the gears, the control disk, and the meter disk. The pawl set is located on this level, as is the balance piston and DO cap. We show how to check this level.
Kinetico level two has the vent tube and the brine flow control, the brine flow control can get blocked.
Kinetico level three has the venturi throat and the throat on this part of the Kinetico must be clear and perfect. We explain how to do this.
Kinetico level four contains the main Kinetico piston flat seals and quad rings. Also, this level has the Kinetico control valve and quad rings, and of course the taper seal sets. In addition, there is the Kinetico backwash flow control. This need to be clear and clean.
Kinetico level five has the drain valves and quad rings. The Kinetico five level has the Kinetico interlock and the cut outs for the Kinetico check stems. Older versions have the small blue Kinetico balls that do the same job, to stop back flow in the system.
Kinetico level six has the Kinetico check stems, and the Kinetico upper distributor. The entire head is attached to the main Kinetico resin bottle by a large thread and immediately below that the upper distributor.
The Kinetico seals involved in keeping this softener working are many, and only one Kinetico seal needs to be faulty to cause everything to fail. We work through everything in detail in our Kinetico videos. We show you a one-minute run through in our eBay listing. We have many videos in detail, in fact detailed video for every level. Hours of information and explained by our Kinetico engineer. Follow his work to get your Kinetico water softener working properly.

For repairs and parts
www.kinetishop.com