3 POINT SADDLE!! HOW TO DO IT THE EASY FAST WAY !! WARHAMMER MASTER CLASS

Will be showing you how to do a 3 point saddle the Warhammer way or as it’s commonly known the push through 😤 method

Measure to the center of your obstruction

Put small mark dead center (ex: 24”)

Measure how high obstacle is (ex: 3in tall )

Multiply that by 3/16 (ex: 3 x 3/16= 9/16)

Put that at the end of your dead center mark (ex: 24 +9/16=24 9/16”)

Make a new mark that goes all the way around the pipe- this is your new center with shirking

To get the outside marks multiply the object by 3 (3X3in tall object= 9 ) from the center go 9in backwards from the center then 9in forward from the center make full marks all the way around

First point bend to 22 degrees on the notch

Second bend twist 180 degrees line up with notch and bend 45 degree

Third bend - twist 180 degree line with notch and bend 22 degree

Bam 💥

#electrician #electriciantricks #3pointsaddle #pipebending #conduit #conduitbending #electrical #electricalknowledge #tradetricks #commericalelectrician #pushthroughmethod
#sparky #sparkytricks #easypipebending