Scopema Swivel Seat Installation - RAM Promaster 2500 Van Build Episode 8

Hi! We are Marc and Tania. Welcome to episode 8 of our RAM Promaster 2500 van build/conversion series. In this video, we install Scopema seat swivels on both of our front seats. We actually had planned to do this project much earlier, but there was a shipping delay on the passenger swivel. Finally, 9 weeks later, we had both of them and were ready to go. One of the reasons we went with the Scopema swivel was the low profile. We even found some websites that showed us a few tricks to make the profile as low as possible. You’ll see how we made these modifications….and how we did the complete passenger seat install in this video. We repeated the same process for the driver’s side. It’s great to be able to just swing the seats around now…..and access the back of the van without stepping outside..

If you have any questions, please feel free to leave a comment below, and please give a thumbs-up if you enjoyed this video and found in helpful to you. Subscribe to our channel to follow along on our entire van build series.

---------------------------------------------------

Here are affiliate links to some of the products we used in the episode:

Torx 40 bit: https://amzn.to/3aDtkqW
5mm Hex bit: https://amzn.to/3AImZF7
Cordless Impact Driver: https://amzn.to/3n3GB1U
Flexible split conduit: https://amzn.to/3j8xeN3
Socket Set: https://amzn.to/3aDu1R4
Phillips head Screwdriver: (for removing and attaching the plastic cover)
Hacksaw: (for cutting off the metal piece under the seat)
Coping Saw: (for cutting the plastic cover)