Emco PC5 Centroid CNC Acorn Conversion: Part 9: Wizard Settings and Wizard Overview

In this unedited video, (be nice!) I try to go over the Wizard settings for the Emco PC5 using the CNC4PC C86Acorn board and Leadshine CS-D508 closed loop steppers, an encoder, and a VFD. I touch on some of the other Wizard settings.

Using these settings would give those setting up a PC5 a starting point. Keep in mind your overall turns ratio may change depending on the pulley tooth count you use on the motor to ball screw (overall turns ratio)

Leadshine drives/motors, C86Acorn and C34 Drive interface board were purchased from https://www.cnc4pc.com/

Latest Centroid Software, schematics and information can be found here:
https://www.centroidcnc.com/centroid_...

Any questions? PLEASE post them to the Centroid CNC Acorn User's Forum:
https://centroidcncforum.com/viewforu...

BE SURE to follow the instructions in this post:
https://centroidcncforum.com/viewtopi...