2013 Mustang GT Clutch And Flywheel

http://www.apdty.com

00:23 - Disconnect Battery
00:44 - Unbolt H Pipe
36:48 - Remove Strut Tower Brace
36:48 - Remove Air Intake Hose
01:45 - Disconnect Shifter
03:06 - Continue Unbolting H Pipe
03:57 - Remove Cross Bar
04:17 - Diconnect Cables and Sensors
05:04 - Continue Removing H Pipe
06:03 - Disconnect Drive Shaft Flanges
07:28 - Disconnect Center Carrier Bearing
07:56 - Remove Drive Shaft
08:09 - Disconnect Starter
10:11 - Disconnect Shifter
11:25 - Remove Transmission Cross Member Support
11:56 - Remove Transmission Bell Housing Bolts
14:00 - Remove Slave Cylinder Line
14:52 - Remove Transmission Housing
15:38 - Remove Pressure Plate
17:27 - Remove Flywheel
18:55 - Remove Pilot Bearing
20:42 - Install New Pilot Bearing
21:23 - Install New Flywheel
24:06 - Install Pressure Plate And Clutch Disk
26:50 - Reinstall Transmission Housing
27:15 - Bolt In Bell Housing
27:48 - Bolt Starter Motor
28:12 - Bolt Cross Member Support
28:46 - Reinstall Cross Beam
29:03 - Reinstall Shifter
29:54 - Reinstall Driveshaft
31:43 - Swap Oxygen Sensors Into New H Pipe
32:38 - Install H Pipe
36:48 - Install Strut Tower Brace And Air Intake Hose
37:52 - Connect Battery
38:01 - Fill Brake Reservoir
38:56 - Finish Reinstalling Shifter And Pumping Clutch