etrailer | Trailer Wiring Harness Installation - 2005 Dodge Dakota

Click for more info and reviews of this CURT Custom Fit Vehicle Wiring:
https://www.etrailer.com/Custom-Fit-V...
https://www.etrailer.com
Don’t forget to subscribe!
   / etrailertv  

Full transcript: https://www.etrailer.com/tv-install-t...
Today on this 2005 Dodge Dakota, were going to install part number 55323 from Curt. First thing we need to do is go ahead and open up the tail gate and get access to the tail lights so we can go ahead and remove them. Alright, with the tail light, well go ahead and disconnect the wiring harness from the light socket that has three wires going through. Now, well go ahead and leave that alone for now. Well take our 4-pole wiring harness and run it through the bottom of the tail light area, and also, well do the same thing with the T-connector half with the green wire. Well take the T-connector with the yellow wire and attach it back to the tail light and then the factory harness to the T wiring harness.

Alright, next, well go ahead and run our 4-pole wire out to the center of the bumper in the end of the hitch, then well go ahead and run the T-connector with the green wire over to the passengers side, not to the tail light. Then well go ahead and zip tie the wires safe and out of the way. Okay, with all our wires bundled, well go ahead and add the cap to the 4-pole and well attach that to the safety chain loop on the hitch. And with that, that will finish it for our part number 55323 from Curt on our 2005 Dodge Dakota.