LS Wiring Harness Part 3 | Project Rowdy Ep015

Part 3 of the LS Wiring Harness Cleanup will cover working my way through each of the bundled legs of wire and removing unwanted Sensors and their related wires.

The goal is to create a Stand a Lone harness that only requires 4 wires to run the engine. There will be additional wires running to the vehicle to support additional features.

Project Rowdy is a restoration on a 1979 Jeep CJ7. This LS Swap Harness is being prepared to be mated back to its original engine: 2001 Chevy Silverado 5.3L LM7 which has just undergone a full rebuild.

References:
Wiring Harness Research: http://www.LT1Swap.com
Wiring Cleanup Procedures: To be published after revisions from this current build
LS Fuse Block and Relay Diagram: http://bit.ly/LS_Harness_Diagrams
PCM and Connectors Pinout Charts: http://bit.ly/PCMandConnectorTables

Tools and Parts used:
Qiorange 8 Pin Connector: http://amzn.to/2lNgMW8
Doorman Fuse Block: http://amzn.to/2kOBR2R
e-Ting 5 Pin Relay Socket: http://amzn.to/2kOzzRk
Absolute RLS125 Relays: http://amzn.to/2lNp4gR
Vice Grip Wire Strippers: http://amzn.to/2lI3fie
Loom Fabric Tape: http://amzn.to/2xZng69

Project Rowdy Playlist:
   • Project Rowdy - Jeep Restoration  

UCanDoIt2 Website: http://www.ucandoit2.club/
UCanDoIt2 Contact: [email protected]

JeepForum Thread:
http://www.jeepforum.com/forum/f22/pr...

Facebook Page:
  / projectrowdy  

Music
Intro: Alex Skrindo (Alive)

#lsswap #lsswaptheworld #lsswapc10 #lsswapc10 #diyperformance #jeep #jeepcj