LowRider v4 DIY CNC - NEW beta test cuts! 150mm/sec! 12mm depth of cut! 1/4” 1-flute V1E bit!

LowRider v4 DIY CNC - NEW beta test cuts - 150mm/sec. 12mm depth of cut. 1/4” 1-flute carbide up-cut end mill from V1E.com. Kobalt router at 3 on dial!

Corrections: Step-over rate was actually 75%, not 50% as stated. Also, I previously mentioned in the description that I thought the steppers were being fed at 1.0 amps, but I think they were getting 0.8 amps. This explains why I could not understand how they were staying so cool.

LR4 cut videos:
Doug’s LR4 Beta MDF pocket cuts —    • LowRider v4 DIY CNC - NEW beta test c...  
Jonathan’s LR4 RC2 Cutting Plywood —    • LR4 Beta RC2 Test Cut  
Philipp's LR4 Beta vs. Aluminium (8.2mm DOC Trochoidal!) —    • LR4 Beta vs. Aluminium (8.2mm DOC Tro...  
Doug’s LR4 Beta hardwood 3000mm/min and 12mm depth of cut —    • LowRider v4 DIY CNC - BETA TEST Amazi...  
Philipp's LR4 Beta Test Box for a Bullitt Cargobike —    • Box for a Bullitt Cargobike - LowRide...  
Philipp's LR4 Beta Test 33 second CNC Drag Race -    • LowRider 4 Beta - 33 second CNC Drag ...  

Links:

Build log for my LowRider v4 CNC (upgrading full size LR3 to LR4): https://forum.v1e.com/t/design8studio...
Free plans for LowRider DIY CNC: https://docs.v1e.com/lowrider/

Jackpot CNC Controller I use on my LowRider: https://www.v1e.com/products/jackpot-...

FluidNC firmware I use on the Jackpot: http://wiki.fluidnc.com/

V1E Theme for FluidNC WebUI v3: https://forum.v1e.com/t/jackpot-fluid...

FluidDial firmware I use on the Pendant: http://wiki.fluidnc.com/en/hardware/o...

My build log for my LowRider v3: https://forum.v1e.com/t/on-upgrade-pa...

My build log for my FluidDial pendant: https://forum.v1e.com/t/fluid-dial-fl...

Various LowRider 3 CNC remixes: https://www.printables.com/social/127...

View all my Design8Studio models and remixes on Printables: https://www.printables.com/social/127...


My PayPal tip jar: https://paypal.me/design8studio


*Amazon product links are affiliate links.