Replace Height Sensor - Range Rover Sport or LR3 (2005-2009)

▼Parts and Tools Listed Below▼
How to replace Range Rover Sport 2005-2009 height sensor to alleviate "Suspension Fault Normal Height Only" errors. This is a follow up video to my original video on how to diagnose a faulty height sensor. This is a relatively cheap and easy fix for a very common RRS problem. Ideally, both front or rear wheel height sensors would be replaced at the same time for symmetry.

The specific sensor you need will depend on whether you are replacing the front/rear and driver/passenger sensor.

Parts needed:
Replacement height sensors (https://amzn.to/3n0vgho)

Front: RRS HSE and RRS SC are the same, but LR3 is different part.
Rear: RRS HSE, RRS SC, and LR3 height sensors are the same.

Tools required:
13mm socket or wrench (for battery terminals)
T20 torx bit (for height-sensor bracket)

The tool set I use - contains all above tools: https://amzn.to/46VKwU4

Works with RRS and LR3 MY 2005, 2006, 2007, 2008, 2009

#rangeroversport #LR3 #rangerover #landrover

Disclaimer:
Due to factors beyond my control, I cannot guarantee against improper use or unauthorized modifications of this information. I (Hazy) assume no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I (Hazy) recommend safe practices when working on vehicles and/or with tools seen or implied in this video. Due to factors beyond my control, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hazy.