Replacing Sway Bar Bushings - Range Rover Sport or LR3 (2005-2009)

▼Parts and Tools Listed Below▼
Range Rover Sport 2005-2009 sway bar (AKA, anti-roll bar, roll bar, or stabilizer bar) bushing replacement. Typically, warn sway bar bushings will present as metal-on-metal clunking when going over bumps as the sway bar hits the bare bracket, replacing the bushings should alleviate this noise.

MAKE SURE to apply grease (silicone or lithium) between the sway bar and the bushing before reinstallation to prevent squeaking/creaking.

ALSO I have successfully changed the sway bushings without jacking up the front end, as long as the wheels are equal in height, changing the bushings on the ground (or on rhino ramps) isn't a problem.

Parts required:
New front sway bar bushings: https://amzn.to/3exIiQc

Tools required:
18mm deep offset wrench: https://amzn.to/369RS8c

The tool set I use for most projects: https://amzn.to/46VKwU4

Works with RRS MY 2005, 2006, 2007, 2008, 2009

#rangeroversport #LR3 #rangerover #landrover

Disclaimer:
Due to factors beyond my control, I cannot guarantee against improper use or unauthorized modifications of this information. I (Hazy) assume no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I (Hazy) recommend safe practices when working on vehicles and/or with tools seen or implied in this video. Due to factors beyond my control, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hazy.