How to make a

This is how I make photo carves with my cnc using photoVcarve software
8 inch
Y 6.2875
Z .75
Cutting parameters and tool i used are
Amana tool tapered ball nose #46282
Diameter 0.0313
Pass depth 0.022
Feed 100 inch/min
Plunge rate 100 inch/min

👉** Carving max depth 0.15 was used for This Carving.
However, Between 0.09 - 0.2 works as well... Good luck and try different settings. **👈

Line angle 45.0*
“ Check the cross hatch box “
rapid Clarence gap 0.25 inch
Please like and subscribe to our channel
Let me know how yours turns out in the Comment section below Thanks for Watching

If you would like to support my youtube channel Please visit my Patreon page @
https://www.patreon.com/BeeManRobert?...

My website on ETSY @ https://www.etsy.com/shop/LittleLarue...
My Pattern website (Made By Etsy) @ https://www.LittleLarueApiary.com
Follow me on Instagram @   / little_larue_apiary_llc  
Fackebook Page @   / littlelarueapiary  

My Youtube Channel    / beemanrobert  

Thanks for Watching.
Please dont forget to subscribe to the channel and like this video