Measuring the 80mm Chinese shell mill inserts height

Last video I tested this 80mm Chinese face mill on the old lathe. It was good fun, and it worked a whole lot better then using my fly-cutter. But I neglected to check if all 6 inserts were helping out with the cut. So lets take some measurements, and have a close look at the cheap inserts that came with the mill. And satisfy all those comments and questions.

FYI: I am trying to make a little money for my youtube hobby through the Banggood affiliates program. Follow the link below, buy something you NEED and I'll earn some commission. Doesn’t cost you anything extra. You're basically taking money out of Banggood's pockets and putting it in mine :)

MT3 Arbor: https://www.banggood.com/custlink/DDv...
Face Mill: https://www.banggood.com/custlink/GKm...

Rolingmetal community tab:: https://bit.ly/2TkLrH0
Rolingmetal photo album: https://bit.ly/2KQJIdu