Mazdaspeed 3 - CFM Oil Breather Cap & Gen 2 Valve Cover Install

In this video we install the Gen 2 Valve cover paired with a CFM Oil Breather Cap to improve the PCV system by reducing crankcase pressure at WOT and allowing oil from the turbo to drain back into the block efficiently. Excessive crankcase pressure causes a whole range of problems, such as leaking oil seals, oil blowing into the turbo inlet from the valve cover breather, excessive gunk build up on the intake valves, smoking turbo's, and dipsticks popping out just to name a few! Having a good vented setup is a must when upgrading the turbo. Enjoy the video! Please like, share, and subscribe :)

*** Please note that my smoking turbo issue has since been resolved as shown in this video:    • Mazdaspeed 3 - Smoking Turbo Fix - Tu...  

Instagram - @wannabe_tuners

Mods in this video:
1. Snow Performance Stage 1 WMI Kit
2. Cobb Accessport V2 (self tuned)
3. Bfg G-force Comp 2 All Seasons
4. Jbr Oil Catch Can (vta setup)
5. Stratified Guardian Angel V3
6. Ngk One Step Colder Plugs
7. Cpe Top Mount Intercooler
8. Jbr 88a Rear Motor Mount
9. Jbr 88a Trans Motor Mount
10. Jbr 80a Pass Motor Mount
11. Autotech HPFP Internals
12. Eibach Lowering Springs
13. Corksport Injector Seals
14. Oem Gunmetal Wheels
15. Cfm Oil Breather Cap
16. Cnt Catted Turboback
17. Koni Yellow Shocks
18. Raceland E-Cutout
19. Gen 2 Valve Cover
20. Cobb 3 Port Ebcs
21. Fidanza Flywheel
22. Htp Full 3" Intake
23. Bnr S4 V2 Turbo
24. Cobb Xle Bpv