Как демонтировать и собрать насосы Grundfos SE1 и SEV без датчика

See how a Grundfos service specialist dismantle and assemble Grundfos SE1, SEV pumps without sensor and find out what the job requires and how it is performed.

The different sections include:
00:00 Introduction

Dismantling:
00:14 Removing the cable
00:38 Removing the pump housing
01:09 Drainage of oil
01:55 Removing the impeller
02:29 Removing shaft seal
04:36 Remove the shaft with rotor and bearings
06:27 Removing the stator and housing
09:55 Removing the moisture switch and water-in-oil sensor(WIO)

Assembly:
11:08 Fitting the moisture switch and water-in-oil sensor(WIO)
13:39 Fitting of stator housing
17:28 Fitting of shaft with rotor and bearings
19:05 Fitting of shaft seal
21:00 Filling of oil
21:33 Fitting of impeller
22:16 Mounting of pump housing
23:22 Fitting the cable
32:06 Replacement of stator


Learn more about SE, spare parts, service kits and additional services and solutions provided by Grundfos on https://product-selection.grundfos.co... and do not hesitate to contact us via http: http://www.grundfos.com/pleasecallus.

DISCLAIMER
This service video provides “how to” guidance for Grundfos products and is aimed only at skilled, trained personnel.

N.B. Any stricter local health and safety regulations and requirements take precedence over this guidance.

The video and any information in it is provided on an “as is” basis and without any liability and/or warranty to the extent permitted by applicable law.

Grundfos reviews and updates the information provided on a regular basis. However, instructions may have changed since publication of this video and therefore please always check the latest Service Instructions and the Installation & Operating Instructions of the related product.

These documents can be found on https://product-selection.grundfos.co....

#pumpservice #pumprepair #grundfospumps #grundfosservice