Как демонтировать и собрать насосы Grundfos SL1 и SLV с датчиком определения воды в масле

See how a Grundfos service specialist dismantle and assemble Grundfos SL1 & SLV pumps with water-in-oil sensor and find out what the job requires and how it is performed.


The different sections include:

00:00 Introduction

Dismantling:
00:13 Removing the cable
00:40 Removing the pump housing
01:15 Removing the impeller
01:46 Draining the oil
03:41 Removing the shaft seal
05:13 Removing the shaft with bearings and rotor
07:03 Removing the WIO-sensor and moisture switch
07:55 Removing the bearings

Assembly:
09:05 Fitting the bearings
10:26 Fitting the WIO-sensor and moisture switch
15:27 Fitting the shaft with bearings and rotor
17:37 Fitting the shaft seal
20:20 Filling with oil
21:22 Fitting the impeller
22:41 Fitting the pump housing
23:25 Fitting the cable

Learn more about SL1 & SLV pumps, spare parts, service kits and additional services and solutions provided by Grundfos on https://product-selection.grundfos.co... and do not hesitate to contact us via http://www.grundfos.com/pleasecallus.

DISCLAIMER
This service video provides “how to” guidance for Grundfos products and is aimed only at skilled, trained personnel.

N.B. Any stricter local health and safety regulations and requirements take precedence over this guidance.
The video and any information in it is provided on an “as is” basis and without any liability and/or warranty to the extent permitted by applicable law.

Grundfos reviews and updates the information provided on a regular basis. However, instructions may have changed since publication of this video and therefore please always check the latest Service Instructions and the Installation & Operating Instructions of the related product.

These documents can be found on https://product-selection.grundfos.co...

#pumpservice #pumprepair #grundfospumps #grundfosservice