WHILL Model Ci: Configuring

Hi, I’m here to show you how the WHILL Model Ci can be configured perfectly to fit your body type.

The seat height can be adjusted to 5 different settings.

First, remove the seat assembly. Then using a 8mm hex key, remove the seat post bolt.

Move the seat post up or down and align with one of the 5 settings that best fits your needs. Insert the bolt that was removed and tighten.

Next, install and secure the seat assembly on the seat post.
To adjust the arm length, first remove the arm cover. To remove, grasp the right and left edges, gently bend outwards and pull towards you.

Locate the arm adjustment tab on the bottom of the exposed arm.

While pulling on the arm adjustment tab, slide the arm up or down to the desired length. The arm length can be set in 4 settings.

Install the arm cover by positioning the tabs on the top end and pressing the arm cover into place.

To change the back support cushion height, start by detaching the cushion from the velcro adhering it to the shell

Using a 4mm hex key lightly loosen the 4 screws.

Once loosened, slide the back-support up or down until you reach the desired height, then secure by tightening the screws.

Return the back cushion to its original position.

The back support angle can be quickly adjusted to 90, 95 and 100 degrees.

To change the back support angle, first locate the two adjustment pins located under the back support and just behind the seat cushion.Tilt the back support slightly forward to release pressure on the adjustment pins..

Next, from the bottom, push the adjustment pin up while turning it to the desired angle. Make sure both the left and right pins are at the same angle.

For more information, please refer to the Model Ci user manual or give us a call.


Visit www.whill.us or call (844) 699-4455.

The WHILL Model Ci is not considered to be a medical device and has not been submitted to the Food and Drug Administration for review or clearance.